CAD Graphics and Drafting

		Subject / Started by	Replies / Views
		In structural work, the hole is approximately ___________ larger than the rivet. Started by Traci	2 Replies 1255 Views
		The thread with flattened roots and crests having a stronger thread describes ____________________. Started by Fabian	2 Replies 534 Views
		That part of a thread that is identified as the top surface where two sides join is called _____________. Started by Jolene	2 Replies 486 Views
		In the thread note .25-20UNC-2B-LH, what is the class of fit? Started by Jerlene	2 Replies 415 Views
		Which of the following screw heads is placed flushed with the surface of the material? Started by Lawerence	2 Replies 614 Views
		The first standardize screw thread was accepted in 1841 and was called the: Started by Ethyl	2 Replies 831 Views
		The abbreviation MMC stands for "maximum material condition." Started by Darron	2 Replies 1072 Views
		The surface texture symbol "M" indicates lay multidirectional. Started by Krystin	2 Replies 323 Views
		The symbol for concentricity is a circle with a cross locating the center. Started by Nicolette	2 Replies 1100 Views
		The symbol for Shrink Fits is FN. Started by Arlie	2 Replies 1094 Views
		Tolerance grades should be as course as possible and still permit satisfactory use of the part. Started by Lessie	2 Replies 1098 Views
		RFS means ______________________________________. Started by Carina	2 Replies 1282 Views
		Neatly draw the surface texture symbol indicated material removal prohibited. ______________ Started by Kizzy	2 Replies 1013 Views
		When intermediate dimensions are held to a specific condition and the overall dimension may or may not be affected, the overall dimension is referred to as a _________________ dimension. Started by Dotty	2 Replies 1041 Views
		Which of the following is a general-purpose thread for holding purposes, designated NC? Started by Dwayne	2 Replies 533 Views
		Which class of fit is recommended for only high-cost situations where continual checking is required? Started by Noelia	2 Replies 1150 Views
		The three basic applications of screw threads are __________, __________, and __________________. Started by Annmarie	2 Replies 1279 Views
		The smallest diameter of a screw thread is called ____________________. Started by Jessica	2 Replies 490 Views
		In the thread designation, .25-20 UNC-2B LH, what is the meaning of "20"? Started by Dayle	2 Replies 717 Views
		The diameter of an imaginary cylinder passing though the threads to make equal the widths of the threads and the widths of the spaces cut by the cylinder describes: Started by Eboni	2 Replies 1267 Views